PowerSwitch Main Page
PowerSwitch
The UK's Peak Oil Discussion Forum & Community
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Clean energy from coal bed gas

 
Post new topic   Reply to topic    PowerSwitch Forum Index -> Hydrocarbons
View previous topic :: View next topic  
Author Message
Aurora



Joined: 24 Jan 2007
Posts: 8502

PostPosted: Thu Aug 16, 2007 4:19 pm    Post subject: Clean energy from coal bed gas Reply with quote

http://www.radionetherlands.nl/features/science/070816rf

Quote:
A new method of extracting energy from coal layers that until now were considered too deep to access can help 'bridge the gap' between today's fossil-fuelled economy and the potential hydrogen economy of the future. Better still, this method can be efficient and clean.

Coal contains methane gas, a combustible gas with a high caloric value that can be used in much the same way as natural gas. Many coal layers are simply too deep underground, or too thin to be exploited in the traditional way. Yet, they can hold large deposits of methane. The Dutch research and development institute TNO has recently conducted a large-scale test in Poland of a new way of extracting this valuable gas.

Existing methods

Extracting gas from coal beds is not entirely new; in several parts of the world, it's already common practice. Civil engineer Henk Pagnier explains how the existing methods work:

"First, you can simply pump away the water column from a coal reservoir at a depth of, say, five to six hundred metres. Thus, the coal is depressurised and the gas naturally escapes. It's a rather crude method and it doesn't get all the gas out of the coal, but it is efficient in easily accessible layers. The method is called CBM, Coal Bed Methane."

"Another method is underground, subsurface gasification of coal. That means that you burn or gasify the coal in the subterranean layers themselves and then harvest the production gasses, mostly hydrogen, but also some methane. It is a complex process and fairly difficult to control. The amount of gas produced can be disappointing and the burning coal beds can be dangerous; rocky layers above the coal can crack or even collapse. Therefore, early attempts in the 1980s were abandoned. Still, new research has begun in the United States and the first results seem promising."

The new method that Henk Pagnier and his colleagues from TNO have been working on is called ECBM, 'Enhanced Coal Bed Methane'. It takes the old CBM method one step further: the methane gas is not simply released naturally by depressurising the coal, but pushed out by injecting another gas, preferably a gas we want to get rid of anyway, like greenhouse gas CO2. Henk Pagnier says:

"The beauty of the whole thing is that CO2 happens to bind to the coal when injected. Better still, it dissolves the methane gas from the coal in the same chemical process. Instead of the 40 percent of gas which can be extracted from the coal by using the old method, CBM, Enhanced Coal Bed Methane can extract up to 80 percent, and that makes the whole concept economically viable in many more cases."

Problem

The purpose of the field experiment in Poland was to prove that the theory could be put into practice. The location was perfect: a depleted CBM production site, where the drill hole for pumping out the water column and harvesting the methane gas could still be used. A second hole was drilled, and CO2 gas pumped in.

The first results were disappointing. Only a minimal amount of methane could be squeezed out, as it were. Dr Pagnier and his colleagues then applied a little trick, inserting a small amount of sand into the CO2. The grains of sand kept open the small cracks that inevitably appear in the coal when pressurised. This hugely enlarged the surface area where CO2 gas could get into direct contact with coal and suddenly the old 'CBM well' did produce promising amounts of Methane.

A closed circle - Dr Pagnier is confident:

"I have no doubt that in the near future we can indeed harvest up to 80 percent of the methane trapped in coal beds. Furthermore, there is so much of it that it can fulfil the energy needs of the planet for about 200 years. That gives us time to make the change to a hydrogen economy. And, as far as I'm concerned, the best thing of all: if you use the methane on the spot for a local power plant, you can use the CO2 that the plant produces for extracting more methane from the coal bed. It's a closed circle. And completely clean."

"Fulfill the energy needs of the planet for about 200 years". We can all stop worrying. Wink
Back to top
View user's profile Send private message
adonispayton



Joined: 05 Dec 2008
Posts: 1

PostPosted: Fri Dec 05, 2008 9:59 am    Post subject: steps to cleaning coal Reply with quote

The concept of clean coal is said to be a solution to climate change and global warming by coal industry groups, while environmental groups maintain that it is greenwash, a public relations tactic that presents coal as having the potential to be an environmentally acceptable option. Greenpeace is a major opponent of the concept because emissions and wastes are not avoided, but are transferred from one waste stream to another

Here is a link that might be useful: http://www.lincenergy.us
Back to top
View user's profile Send private message
dwayne.eri
Guest





PostPosted: Fri Mar 06, 2009 12:49 pm    Post subject: Coal Cleaners Reply with quote

The concept of clean coal is touted as an environmentally acceptable solution to climate change and global warming by coal industry groups. Greenpeace is a major opponent of the concept because emissions and wastes are not avoided, but are transferred from one waste stream to another.

Coal Cleaners
Back to top
Display posts from previous:   
Post new topic   Reply to topic    PowerSwitch Forum Index -> Hydrocarbons All times are GMT + 1 Hour
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group