PowerSwitch Main Page
PowerSwitch
The UK's Peak Oil Discussion Forum & Community
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Cardboard briquette fuelled biomass

 
Post new topic   Reply to topic    PowerSwitch Forum Index -> Biofuels & Biomass
View previous topic :: View next topic  
Author Message
Jhutchinson



Joined: 18 Jul 2013
Posts: 1

PostPosted: Thu Jul 18, 2013 12:32 pm    Post subject: Cardboard briquette fuelled biomass Reply with quote

I'm looking at a biomass feasibility proposal for a food product manufacturer that proposes to use approximately 3 tonnes of fuel per week to create hot water that is then fed into a boiler to produce steam.

The project is not that straight forwards as it proposes to use a non-standard fuel (briquettes made from egg cartons). The main barriers for progression that I have noted include:

1. Burning the material
2. The disposal of ash
3. The reliability of biomass burners when using this material

1. As far as Iím aware cardboard and paper products (including egg box briquettes) are not eligible for the same exemption from the Waste Incineration Directive (WID) as waste wood. This means to burn the fuel would require WID approval from either the Environment Agency or Local Authority depending on the volume of fuel being burnt.

2. Due to the nature of the material the ash produced falls under the waste disposal regulations. This is partly because the preferred route of disposal for card products is recycling and not energy recovery. It is also because within the material there are usually a wide range of contaminants including bleaches (ie chlorine), fillers, dies, pigments, finishes, adhesives, etc. This makes beneficial use of the ash difficult and in some cases the ash may be classified as hazardous (even more barriers!). There are a number of new waste exemptions to allow certain forms of waste, including ash from burning untreated wood and vegetable waste, that have been brought in by the Environment Agency but I can find no reference to paper / card products.

3. Although biomass is now an established sector the majority of burners use fuel such as wood chip or pellets. To my knowledge the reliability of a burner using cardboard briquettes is not heavily tested.
If the proposal went ahead the business could create 3 tonnes of fuel per week to be used as fuel.


Does anyone know of a manufacturer that specialises in non-standard biomass fuel burners?
Also does anyone have any clever ideas for the disposal of the ash?
Back to top
View user's profile Send private message
PS_RalphW



Joined: 24 Nov 2005
Posts: 5267
Location: Cambridge

PostPosted: Thu Jul 18, 2013 1:18 pm    Post subject: Reply with quote

I'm no engineer, but I suspect that standard biomass boilers would need considerable changes to burn a low density fuel like cardboard briquettes safely, efficiently and reliably. I'm also not sure how easy it would be make the briquettes sufficiently uniform in size, shape and composition.

I cannot see any boiler manufacturer wanting to build a one-off boiler with the considerable development and certification it would require for what sounds like an almost unique fuel source.

The briquettes would need a very low water content to burn efficiently enough to meet smoke emissions regulations. The project is obviously intended to extract heat from a low grade waste product at relatively low temperatures. The best boilers raise the combustion to nearly 1000C.
Even at these temperatures, the contaminants you list risk producing dioxins as a side product of inadequate combustion. These are deadly toxins.

I'm not sure you aren't getting out of your depth on this project...

http://www.dioxinfacts.org/sources_trends/the_way.html
Back to top
View user's profile Send private message
kenneal - lagger
Site Admin


Joined: 20 Sep 2006
Posts: 9822
Location: Newbury, Berkshire

PostPosted: Thu Jul 18, 2013 5:14 pm    Post subject: Reply with quote

Rather than going for briquettes which I would think would involve wetting the card, pressing it and then drying it again before burning, why not use an established technology like pellets. There are plenty of off the shelf machines that could be used to pelletise the card and plenty of proven pellet boilers of all sorts of sizes to burn the stuff.

Don't try to reinvent the wheel.

You would probably have to have a test batch of fuel chemically tested before burning so that the contaminants could be identified and the waste products predicted. If you were within safe levels of chlorine and other dangerous contaminants you could go ahead with the project.

Pellets are made from all sorts of biomass even including pampas grass so I wouldn't have thought card would be a problem.
_________________
"When the last tree is cut down, and the last river has been poisoned, and the last fish has been caught, Only then will you find out that you cannot eat money". --The Cree Indians


Last edited by kenneal - lagger on Thu Jul 18, 2013 5:20 pm; edited 2 times in total
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Catweazle



Joined: 17 Feb 2008
Posts: 2189
Location: Little England, over the hills

PostPosted: Thu Jul 18, 2013 5:17 pm    Post subject: Reply with quote

I would have thought that the best way to use old egg cartons is to make new egg cartons from them.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    PowerSwitch Forum Index -> Biofuels & Biomass All times are GMT + 1 Hour
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group